Brandt CA2950E User Manual download pdf (Page 37)

INSTALLATION

Location

The appliance should be installed well away from

sources of heat such as radiators, boilers, direct

sunlight etc.

Electrical connection

Before plugging in, ensure that the voltage and

frequency shown on the serial number plate

correspond to your domestic power supply. Voltage

can vary by ±6% of the rated voltage.

For operation with different voltages, a suitably sized

auto-transformer must be used.

The appliance must be earthed.

The power supply cable plug is provided with a

contact for this purpose.

If the domestic power supply socket is not earthed,

connect the appliance to a separate earth in

compliance with current regulations, consulting a

specialist technician.

The Manufacturer declines all responsibility if

the above safety precautions are not observed.

This appliance complies with the following

E.E.C. Directives:

- 87/308 EEC of 2/6/87 relative to radio interference

suppression.

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modifications;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modifications.

ATTENTION!

It must be possible to disconnect the appliance from

the mains power supply; the plug must therefore be

easily accessible after installation.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

No comments

Brandt CA2950E User Manual Page 37